Call Us
Garage Door Cables

Garage Door Cables Richmond Hill

garage door cables Richmond hill

For the best effect on your garage door cables in Richmond hill, we use various types of springs. Springs that sit above the garage door are torsion springs, and you should not try to remove or replace them.

It is a dangerous job best handled by a professional. If you are trying to replace the cable that runs through a garage door.

First, you must relieve the spring tension. Second, you have to do this with extreme caution. Garage door cables play a vital role in the movement of your garage door.

Once these cables break, garage doors tend to lean on one side that puts extra pressure on the garage door tracks.

This leads to an expensive repair bill. Now, you can prevent a non-functional garage door by fixing broken cables immediately.

Most of the work realigning the new is to cable with the garage door cable drum. Although a few steps are necessary, you need a cable cutter and a little arm force to perform this repair.

High Quality Garage Door Cables In Richmond Hill

Garage door repair Richmond Hill, uses the best technique and materials. Now, we are going to explain step by step how we do it, we Don’t recommend DIY projects as they can become vital.
 
First, we remove the cable from the drum by sliding it off the head plate. Next, we inspect the cable drum and note where the cable comes in and out. 
 
Then, the output marked by a set screw that holds the cable in place. After, mark where the cable enters the cable drum and where the cable meets the cable drum first.
 
By wrapping the cable with a strip of insulation tape at the point of entry. Last, we remove the ball bearing plate with the screwdriver. 
 
This step exposes the cable hole that feeds through to reach the other side and the adjusting screw. Finally, we loosen the adjusting screw on the other side of the drum and remove the cable from the drum.

 

Alignment Is Crucial

Next, we align the new cable with the old cable. Starting at the beginning of the cables, which start with a small loop.
 
Then, we run them together through your tight hand (which ensures the old and the new cable have the same length).
 
And, continue running through until you reach the black electrical band. Also mark the new cable with black electrical tape.
 
Then, insert the new cable into the cable drum, threading it through the opening. And through the small hole underneath the ball bearings. 
 
Flow through until the black electrical tape meets the drum. Finally fasten the new cable by tightening the adjusting screw.
 
And insert the ball bearing plate again by pressing it.  Also, you need to make sure that all the garage door rollers are in place.

Verity Of Replacement Parts

Our team come with at least two people to preform this job. We use locking pliers to hold the door in place and ensure your safety. 
 
Further, we place the handles under the bottom roller that the door slides on. Remove all remaining spring if it’s broken. 
 
Also, we look at all the sheaves and determine if you need to replace them. The bearings and the area around where the cables are touching. 
 
We carry a verity of replacement parts on our tracks making it very easy and convenience for you. Garage door service Richmond Hill specializes with garage door installation and opener installation.
Callback
Fast Service
Quality Control